You have to minimize the game then enable the overlay and maximize the game again or the overlay will flicker hard. the AMD overlay does not work correctly in the DX11 mode. Just use either DX9 + D912PXY or the DX11 mode of the game to fix this.ītw. Your frame rates are higher now, but the frame pacing is still unplayable and you are still nowhere near the performance your GPU could reach in the game. You might have already noticed that this does not fix the stuttering issue. What you have done is increasing the minimum 3D frequency of your GPU to 2.3 GHz, so your GPU can no longer adjust its clock speeds and power consumption in 3D applications. AMD can't fix it because there is nothing to fix for them. This is known for 2 years and it has nothing to do with the AMD driver. The GPU will enter the idle state and run at 700 to 900 MHz causing low frame rates and heavy stuttering. The DX9 mode of GW2 can cause GPU utilisation issues on RDNA and RDNA2 GPUs. Hope this will help someone not going through all the testing, reinstalling and coffee I had to. In my Home Instance I get over 200+ FPS while facing some directions and lower while facing others, but never 25-30 FPS.Įven so, my GPU barely gets used and GPU power usage barely hits 180W, but then again I have to remember this is DX9 (not using DX11).Ĭonclusion: AMD's drivers are being written in a dark room lit only by a candle, by a blind man without a keyboard. This instance is an outlier and that is why I chose it as an example. In Cold War Strike where I was getting 25-30 FPS while being alone, now I get 60 FPS. Only after doing this my Guild Wars 2 client performed better. In my case, the numbers are taken from the Sapphire's website for my specific model. Set it up like in this image, being careful to input a reasonable minimum and maximum frequency. Now, on the same page, but on the left side click on Global Tuning button and select Guild Wars 2.Įnable GPU Tuning and under it enable Advanced Control. On this page, on the right side click on Add Game Profile button and select Guild Wars 2 from the list. Open AMD's Radeon Software, click on Performance top right then click Tuning. To not make this post longer than it needs to, this is what I did to make my Guild Wars 2 client perform a lot better.įigured out what is the maximum speed and the boost speed of my GPU. But they were the same as with my old GTX 1080 ti. Indeed, I had all the setting cranked to the max. To cherry on top that made me look harder for a solution was entering alone in the Cold War Strike instance and discovering I had 25-30 FPS standing still. GPU temperature never goes above 45 Celsius and Hotspot temperature never above 55 Celsius. Usual tricks found online did not seems to fix anything for Guild Wars 2 client performance, like turning off Fast Startup, making sure the temperatures are low enough, drivers updates, etc. Performance seemed to plummet and being a new AMD GPU user, could not understand why. Recently I could afford to get an upgrade to an RX 6900 XT from Sapphire and expected at least a bit more performance, but to my surprise, it was the other way around. Performance was decent but a lot of stuttering when turning and opening the map.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |